Trojan POWER GYM 1.0 - Cable 37 Installation; Step 9: Cable 37 Pulley System

16
POWER GYM 1.0
ASSEMBLY STEPS
STEP 9: CABLE 37
Installing the pulley system:
1. Install Pulley (32)
F
and 2 Pulley Hooks (55) to the Reverse U (20) using 1 Hex Bolt (59), 2 Washers (67)
and 1 Nylon Nut (70).
2. Install Pulley (32)
G
and 2 Pulley Hooks (55) to the Reverse U (20) using 1 Hex Bolt (59), 2 Washers (67)
and 2 Nylon Nuts (70).
3. Install Pulley (32)
E
and 2 Pulley Hooks (55) to the Single Pulley Block (21) using 1 Hex Bolt (59), 2 Washers (67)
and 2 Nylon Nuts (70).
Threading the cable through the pulley system:
4. Attach end of Cable (37) to the Left Buttery Arm (11) by hooking the steel loop onto the steel hooks welded
behind the arm.
5. Thread Cable 37 over Pulley (32)
F
which is attached to the side of the Support Frame (8) and down towards
Pulley (32)
G
situated behind the Support Frame (8).
6. Thread Cable 37 under Pulley (32)
G
and back up towards Pulley (32)
E
.
7. Thread Cable 37 over Pulley (32)
E
and attach the nal open end to the hook located behind the Left
Buttery Arm (11).
8. Attach end of Cable 37 to the Right Buttery Arm (12) by hooking the steel loop onto the steel hooks welded
behind the arm.
STEP 9
ASSEMBLY STEPS
37
Step 1 Step 2 Step 3
36
37
35
36
37
36
36
35
35
26
B
D
A
C
E
F
G
L
H
K
J
#19M02T008 Power Gym 1.0 UM VERSION 4.indd 16 29/05/2019 13:30