EN 5
layer thickness measuring device BB20
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• protected from dust and direct sunlight
• For storing the device, use the transport case included in
the scope of delivery in order to protect the device from
external influences.
• The storage temperature is the same as the range given in
the Technical data chapter.
• Remove the batteries from the device.
Operation
Inserting the batteries
• Insert the supplied batteries before first use.
1. Loosen the screw and open the battery compartment(6).
2. Insert the new batteries in the battery compartment(6)
with correct polarity.
3. Place the cover back on the battery compartment(6) and
reinsert the screw.
Switching the device on
Info
Note that moving from a cold area to a warm area can
lead to condensation forming on the device's circuit
board. This physical and unavoidable effect can falsify
the measurement. In this case, the display shows
either no measured values or they are incorrect. Wait a
few minutes until the device has become adjusted to
the changed conditions before carrying out a
measurement.
1. Press the Power button(7).
ð The display will be switched on and the device ready for
operation.
Menu
Press the Red button(9) to open the main menu.
Press the (3) or button(8) to select the desired menu
item.
In order to confirm the selected menu item, press the Red
button(9) again.
Press the Blue button(2) to return to the previous menu item.
To Next Page
Loading...
Need help?
General
