Trotec BE44 User Manual

EN 7
clamp meter BE44
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device use a suitable bag to protect it from
external influences.
Storage
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• protected from dust and direct sunlight
• with a cover to protect it from invasive dust if necessary
• The storage temperature is the same as the range given in
the Technical data chapter.
• Remove the batteries from the device.
Operation
Inserting the batteries
Insert the batteries contained in the scope of delivery (3 x 1.5V
AAA) before first use.
Note
Make sure that the surface of the device is dry and the
device is switched off.
Please proceed as follows to insert the batteries into the device:
1. Loosen the screw and open the cover of the battery
compartment.
2. Insert the batteries into the battery compartment with
correct polarity.
3. Close the battery compartment and fasten the cover in
place.
Info
Please note that moving from a cold area to a warm
area can lead to condensation forming on the device's
circuit board. This physical and unavoidable effect can
falsify the measurement. In this case, the display
shows either no measured values or they are incorrect.
Wait a few minutes until the device has become
adjusted to the changed conditions before carrying out
a measurement.
Attaching the warning sign
Prior to initial start-up, check whether the warning sign at the
rear of the device is in your local language, if not, paste the
proper one over it. A warning sign in your native language is
supplied along with the device. Please proceed as follows to
attach the warning sign to the rear of the device:
1. Remove the label in your local language from the supplied
film.
2. Stick the label on the intended position at the rear of the
device.
Voltage measurement
Warning of electrical voltage
Risk of electric shock and risk of injury!
• Make sure to observe the device's nominal voltage
specified in the technical data during the measurement.
• Check the measuring lines for damaged insulation before
each measurement.
• Test the device for proper functioning at a known voltage
source before each measurement.
• Do not use the device if the wear indicator for the clamping
jaws(1a) is no longer visible.
• When holding onto the measuring cables, make sure not to
reach behind the protection against contact(12):
Please proceed as follows to measure the DCvoltage:
1. Connect the black measuring cable(14) to the
COMconnection(7) and the red measuring cable(13) to
the Input connection(6).
2. Turn the rotary switch(3) to position36.
ð The direct current icon is displayed in the direct current
indication(28) on the display.

Trotec BE44 Specifications

General

Brand	Trotec
Model	BE44
Category	Measuring Instruments
Language	English