Trotec BX50 MID - Disposal Guidelines

EN 7
energy consumption measuring device BX50 MID / BX50 MID F / BX50 MID C
Disposal
Always dispose of packing materials in an environmentally
friendly manner and in accordance with the applicable local
disposal regulations.
The icon with the crossed-out waste bin on waste
electrical or electronic equipment is taken from Directive
2012/19/EU. It states that this device must not be disposed of
with the household waste at the end of its life. You will find
collection points for free return of waste electrical and electronic
equipment in your vicinity. The addresses can be obtained from
your municipality or local administration. You can also find out
about other return options that apply for many EU countries on
the website https://hub.trotec.com/?id=45090. Otherwise,
please contact an official recycling centre for electronic and
electrical equipment authorised for your country.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
Only for United Kingdom
According to Waste Electrical and Electronic Equipment
Regulations 2013 (SI2013/3113) (as amended) devices that are
no longer usable must be collected separately and disposed of
in an environmentally friendly manner.
Overview of the MID measuring devices used
Use the following table to manage the MIDdevices used.
No. Manufac-
turer
Type
designation
Year in which the
measuring device
has been
designated
Address of person
using the measuring
device
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Declaration of conformity
The device has a factory calibration which replaces the initial
calibration by a calibration authority. This is certified by a
MIDDeclaration of Conformity according to
EUDirective2014/32/EU. The validity of this declaration expires
8years after placing on the market. Afterwards the user of the
measuring device is obliged to have the device recalibrated. The
year of initial calibration is indicated on the device after
theCEmark. Example:
M24
0598
M24: The device was manufactured and first calibrated in2024.
If the device is also placed on the market in2024, the
calibration validity ends at the end of2032. If the device is not
placed on the market until2025, the calibration validity ends at
the end of2033.
0598: Number of the accredited calibration laboratory.
Here: SGS
The following page shows the original declaration of conformity
certifying compliance with the relevant regulation.