Trotec LV Series - Setting the Date; Time; Local Settings

B - 7
Operating manual – Infrared camera
Setting the date and time
You need to set Data / Time when the IR camera is turned
on for the first time.
1. Check that the IR camera is in null mode.
2. Press the MENU/ENTER
key, then press the
Up or Down ar-
row on the omni se-
lector to select the
[Setup] menu.
3. Press the Up or
Down arrow on the
omni selector to select
[Date & Time], then press the MENU/ENTER key.
4. Setting Date and time.
  •Press the  Up or
Down arrow on
the omni selector to
select a new field.
  •Press the3Left or
Right 4 arrow on the
omni selector to set
the values.
5. After adjusting the settings, press the Menu / Enter
key to close menu window, or press the C key to
exit without saving.
Local Settings
In this menu item, you can display further settings of the
built-in menu system.
1. Check that the IR camera is in null mode.
2. Press the MENU/ENTER
key, then press the
Up or Down ar-
row on the omni
selector to select
the [Setup] menu.
3. Press the Up or Down arrow on the omni
selector to select [Local], then press the
MENU / ENTER key.
4. Local settings.
 • Press the  Up or
Down arrow on
the omni se-
lector to select
a new field.
  •Pressthe3 Left or
Right 4 arrow on
the omni selector to
set the values.
5. After adjusting the settings, press the Menu / Enter
key to close menu window, or press the C key to
exit without saving.
About the local settings
Language . . . . . Selects the language used in the menus
and messages.
IR/Vision . . . . . . . . . . . . . . . . Selects the displayed mode.
Temp unit . . . . . . . . . . . Sets the format of the displayed
temperature unit of the camera. °C or °F.
Distance unit . . . . . . . . . . Sets the format of the displayed
distance unit of the camera. Meter or
Foot.
Video output . . . . Sets the format of the video output of
the camera. PAL or NTSC.
3
3
3
3
3
3
3
3
3
3
3
3