Trotec PAC 2010 E - Transport, Storage, and Unpacking

5 EN
Operating manual – local air conditioner PAC 2010 E / PAC 2610 E
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before transporting the device, proceed as follows:
• Switch off the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
• To make the device easier to transport, it is fitted with
wheels.
• Do not use the power cable to drag the device.
• Only wheel the device on a level and smooth surface.
After transporting the device, observe the following:
• Set up the device in an upright position after transport.
• Leave the device to rest for 12-24hours, so the
refrigerant can accumulate within the compressor. Wait
12-24hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
Storage
Before storing the device, proceed as follows:
• Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
• Carry out the self-cleaning function to prevent the
formation of moisture within the device during a longer
period of non-use.
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and
direct sunlight
• with a cover to protect it from invasive dust if necessary
• Place no further devices or objects on top of the device to
prevent it from being damaged.
• Remote batteries from the remote control.
Assembly and installation
Scope of delivery
• 1x device
• 1 x exhaust air hose
• 1x hose adapter
• 1x condensation drain hose, length: 0.3 m,
diameter: 14 mm
• 1x hose connector
• 1x two-part flat nozzle
• 2 x clamping piece
• 1x rubber stopper
• 1x retaining clip
• 1 x remote control
• 2 x power cable holder
• 3 x screw
• 1x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.