7 EN
Operating manual – local air conditioner PAC 3500 E
How to use the insert
• Affix the insert in the window gap and adjust the length as
needed. If required, use the extension piece.
• Connect the flat nozzle to the insert.
• Connect the end of the exhaust air hose to the flat nozzle
in the insert.
• Close the window until the insert is held securely.
For installing the exhaust air hose please observe the following:
• Avoid kinks and bends in the exhaust air hose, as they
would lead to an accumulation of emitted humid air
causing the device to overheat and shut down.
• The dimensions of the exhaust air hose were especially
made to fit the device. Do not replace or extend the hose,
for it could cause a malfunction.
Connecting the power cable
• Insert the mains plug into a properly secured mains
socket.
To Next Page
