EN 8
Operating manual – air cooler PAE 51
Inserting honeycomb filter and air filter
Note
When set to air cooling mode, the device should not be
operated without the honeycomb filter, otherwise
cooling will not work.
Note
Do not operate the device without an inserted air filter!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
• Make sure that both the honeycomb and the air filter are
installed before switching the device on.
Adjusting the ventilation flaps
• Prior to switching the device on, adjust the ventilation flaps
at the air outlet.
Connecting the power cable
• Insert the mains plug into a properly secured mains
socket.
Info
An acoustic signal will be emitted; the device is now in
standby mode.
Operation
• Avoid open doors and windows.
Operating elements
17 18 19
20
21
22
23
24
25
262728
29
30
No. Designation Meaning
17 Cooling/
Humidification button
Switching the air cooling mode on
or off
18 Cooling/
Humidification LED
Illuminated when air cooling mode
is activated
19 Hours LEDs Indication of the number of hours
of the activated timer 1h, 2h, 4h
and 8h
20 Ventilation LED Illuminated when ventilation mode
is activated
21 Air freshening LED Illuminated when air freshening
mode is activated
22 Night mode LED Illuminated when night mode is
activated
23 Mode button Selection button for ventilation, air
freshening and night mode
24 Timer button Switching the timer on or off
25 Speed button Setting the fan speed and the filter
drying function
26 Fan stage LEDs
I
II
III
Fan speed indication is
illuminated:
Silent stage = ultra-silent
operation
Stage 1 = low
Stage 2 = medium
Stage 3 = high
27 On / Off LED Illuminated during operation
28 Oscillation LED Illuminated when swing function
is activated
29 On / Off button Switching the device on or off
30 Oscillation button Switching the swing function on
or off
To Next Page
Loading...
Need help?
General
