Trotec T660 Operation Manual

EN 3
moisture measuring device T660
Intended use
Only use the device for the moisture measurement of building
materials. Observe and comply with the technical data.
To use the device for its intended use, only use accessories and
spare parts which have been approved by Trotec.
Improper use
Do not use the device in potentially explosive atmospheres, for
measurements in liquids or at live parts.
Any unauthorised changes, modifications or alterations to the
device are forbidden.
Personnel qualifications
People who use this device must:
• have read and understood the operating manual, especially
the Safety chapter.
Residual risks
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Caution
Keep a sufficient distance from heat sources.
Note
To prevent damages to the device, do not expose it to
extreme temperatures, extreme humidity or moisture.
Note
Do not use abrasive cleaners or solvents to clean the
device.
Information about the device
Device description
The material moisture measuring deviceT660 is a dielectric
moisture indicator, which can be used for the quick and non-
destructive localization of humidity or moisture distributions.
The device enables the detection of near-surface moisture in
walls or flooring. The measured values will be displayed in real
time.
A minimum, maximum and average function is available for the
direct analysis of the measured data. Besides, the currently
measured value can be recorded via the hold function.
The device further features an alarm function. Once the preset
limit value is exceeded, the device alerts the user through
emitting an acoustic signal!
The device is suited for the preliminary check of the building
materials' readiness for covering for subsequent measurements
according to the calcium carbide method (CM measurement).
The moisture indication allows the localization of the most
significant measuring spots to extract material for the CM
measurement.
You can connect the device to a computer by using the USB
cable included in the scope of delivery. Then you can extract
and analyse your measured results with the optional
MultiMeasure Studio software.
Device depiction
1
4
3
2
5
6
No. Designation
1 Display
2 Cross control
3 Battery compartment with cover
4 Power button
5 USB interface
6 Measuring head

Trotec T660 Specifications

General

Penetration Depth	Up to 40 mm
Operating Temperature	0 °C to +50 °C
Measurement Range	0 to 200 digit
Resolution	0.1 digit
Display	LCD