EasyManuals Logo

Trotec T660 Operation Manual

Trotec T660
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10 EN
moisture measuring device T660
Measured value assessment for building material
For building materials the measurement results of the dielectric
measuring method can only be used as reference for a rough
orientation. Conclusions with respect to absolute humidity in
mass % (M%) can only be drawn for measurements, performed
with the exact same marginal conditions and compositions of
the building material as indicated for the test set-up in the chart
below.
This graph was created in collaboration with the Institute of
Building Materials Research of the RWTH Aachen (IBAC) and
illustrates the correlation between the measured value and the
mass-related moisture content of the examined building
materials.
Key
a Moisture content (M%)
b Measured value (digits)
Anhydrite floating screed (conversion: M% = CM%)
Cementitious screed (conversion: CM% = M% -1.5 to 2)
C 30/37 concrete (conversion not possible)
The spread of the achieved measurement results for the
dielectric measuring method is clearly higher than for the
resistance measuring method. The dielectric measuring method
is not suited for the quantitative, but only for the qualitative
moisture measurement in near-surface areas.
The indicated measured values are not the result of a qualified
moisture measurement as per VOB (German Construction
Contract Procedures) or relevant specialist regulations.
The measured values are only to be interpreted as indicators
(dry, damp, wet).
For building materials the measurement results of the dielectric
measuring method can only be used as reference for a rough
orientation.
Display [digit] Building moisture zone
< 40 digits dry
40 – 80 digits damp
> 80 digits wet
PC software
Use the MultiMeasure Studio Standard PC software (free
standard version) or MultiMeasure Studio Professional (paid
professional version, dongle required) to carry out a detailed
analysis and visualisation of your measured results. You can
only use all configuration, visualisation and functional options of
the device when using this PC software and a TROTEC
®
USB
dongle (professional).
Installation requirements
Ensure that the following minimum requirements for installing
the MultiMeasure Studio Standard or MultiMeasure Studio
Professional PC software are fulfilled:
Supported operating systems (32 or 64bit version):
– Windows XP from service pack 3
– Windows Vista
– Windows 7
– Windows 8
– Windows 10
Software requirements:
– Microsoft Excel (to display stored Excel files)
– Microsoft .NET Framework 3.5SP1 (is automatically
installed during software installation, where applicable)
Hardware requirements:
– Processor speed: 1.0GHz, minimum
– USB connection
– Internet connection
– 512MB RAM, minimum
1GB hard disk space, minimum
optional: TROTEC® USB dongle (Professional) for using the
professional version of the PC software
Installing the PC software
1. Download the current PC software from the Internet. To do
so, visit the website www.trotec.de. First click on products
and services, then on services and downloads. Then select
Software in the category menu. Select the MultiMeasure
Studio Standard software from the list. If you want to use
the optionally available professional version of the PC
software "MultiMeasure Studio Professional" (dongle),
then get in touch with your TROTEC
®
customer service.
2. Double-click on the downloaded file to start the
installation.
3. Follow the instructions of the installation wizard.

Other manuals for Trotec T660

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trotec T660 and is the answer not in the manual?

Trotec T660 Specifications

General IconGeneral
Penetration DepthUp to 40 mm
Operating Temperature0 °C to +50 °C
Measurement Range0 to 200 digit
Resolution0.1 digit
DisplayLCD

Related product manuals