Trotec TTK 100 E - Device Operation; General Operation and Fan Behavior; Control Panel Overview; Switching the Device On

8 EN
dehumidifier TTK 100 E
Operation
• Avoid open doors and windows.
• After being switched on, the device operates fully
automatically.
• The fan permanently runs in dehumidification mode even
after the set nominal value has been reached until the
device is switched off.
Operating elements
8
9
10 11 12 13 14
No. Designation Meaning
8 TANK FULL LED Condensation tank full or not
inserted correctly
9 Segment display Indicates the current relative room
humidity.
Indicates the desired relative room
humidity during setting
Indicates the number of hours
during timer programming.
10 Power button Switching the device on or off
11 Timer button Switches the timer function on or
off.
For setting the number of hours for
the timer (1h to 12h)
12 Arrow button down For setting the relative humidity
level (30% to 80%RH in
increments of 10%)
13 Arrow button up
14 Speed button For setting a high or low fan speed
Display
20
21
19
18
17
16
15
No. Designation Meaning
15 Condensation tank full
indication
Is displayed when the
condensation tank is full or not
installed correctly
16 Indication of the target
humidity value
Indicates the desired humidity
level (30% to 80%RH).
17 Fan speed indication One drop: low fan speed
Two drops: high fan speed
(function for drying laundry)
18 Automatic defrost
indication
Is displayed during automatic
defrost.
19 Indication of the timer
and the operating time
Indicates the set number of
hours for the timer and the
operating time.
20 Room temperature
indication
Indicates the current room
temperature.
21 Room humidity indication Indicates the current relative
room humidity.
Indicates the desired humidity
level.
Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
1. Press the powerbutton(10).
ð The device starts to dehumidify.