Trotec TTK 53 E - Device Depiction and Transport;Storage; Component Identification; Transporting the Device; Storing the Device

6 EN
dehumidifier TTK 53 E / TTK 72 E
Device depiction
1
2
3
4
5
6
7
8
9
2
3
10
No. Designation
1 Control panel
2 Transport handle
3 Wheels
4 Air inlet with air filter
5 Condensation drain hose connection
6 Condensation tank
7 Air filter
8 Condensation drain hose
9 Air outlet
10 Colour LED for current room humidity
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Please note that additional transport regulations might apply to
devices containing flammable refrigerants. The equipment's
arrangement and the maximum number of components to be
transported together can be gathered from the applicable
transport regulations.
To make the device easier to transport, it is fitted with wheels.
Before transporting the device, observe the following:
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
• Do not use the power cable to drag the device.
• Only wheel the device on firm and level surfaces.
After transporting the device, proceed as follows:
• Set up the device in an upright position after transport.
Storage
Before storing the device, proceed as follows:
• Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
• Only store the device in a room measuring more than 4m
2
.
• Only position the device in rooms where there is no source
of ignition (e.g. open flames, an active gas appliance or an
electric heater).
• Store the device in a dry location and protected from frost
and heat.
• Store the appliance in an upright position where it is
protected from dust and direct sunlight.
• If required, use a cover to protect the device from invasive
dust.
• Place no further devices or objects on top of the device to
prevent it from being damaged.