Trotec TTK 54 E - Tank Management and Post-Maintenance; Condensation Tank Emptying and Cleaning; Post-Maintenance Device Restart

EN 14
Operating manual – dehumidifier TTK 54 E / TTK 66 E
4. Reinsert the air filter into the device.
Emptying the condensation tank
If the condensation tank is full or not inserted correctly, an
acoustic signal will be emitted. Moreover, the Full indication(14)
will be illuminated and the error codeP2 will be indicated on the
segment display(22). The compressor and fan will switch off.
1. Take the condensation tank out of the device.
MODE ON/OFFTIMERTURBO
ION
On
O
Full
Dryer
SMDCont.
2. Empty the condensation tank over a drain or sink.
3. Rinse the tank with clear water. Clean the tank regularly
using a mild cleaning agent (no detergent!).
4. Refit the condensation tank into the device.
Make sure not to damage the float when inserting or
removing the condensation tank.
In doing so, make sure that the float is positioned correctly.
In doing so, make sure that the condensation tank is
inserted correctly, for otherwise the device cannot be
switched back on.
MODE ON/OFFTIMERTURBO
ION
On
O
Full
Dryer
SMDCont.
Activities required after maintenance
If you want to continue using the device:
• Leave the device to rest for 12-24hours, so the
refrigerant can accumulate within the compressor. Wait
12-24hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
• Reconnect the device to the mains.
If you do not intend to use the device for a considerable time:
• Store the device according to the Storage chapter.