EasyManua.ls Logo

Trotec ttk 71 e - Transport and Storage Guidelines

Trotec ttk 71 e
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6 EN
dehumidifier TTK 71 E
Device depiction
1
2
3
4
5
6
7
8
No. Designation
1 Control panel
2 Air inlet with air filter
3 Condensation drain hose connection
4 Condensation tank with filling level indicator
5 Air filter
6 Feet
7 Transport handle
8 Air outlet
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a carry
handle.
Before transporting the device, observe the following:
Switch off the device.
Hold onto the mains plug while pulling the power cable out
of the mains socket.
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
Do not use the power cable to drag the device.
After transporting the device, observe the following:
Set up the device in an upright position after transport.
Leave the device to rest for 12to24hours, so the
refrigerant can accumulate within the compressor. Wait
12to24hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
Storage
Before storing the device, proceed as follows:
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
Only store the device in a room measuring more than 4m
2
.
Dry and protected from frost and heat
In an upright position where it is protected from dust and
direct sunlight
With a cover to protect it from invasive dust, if necessary
Place no further devices or objects on top of the device to
prevent it from being damaged.

Related product manuals