Trotec ttk 71 e - Operation Basics; Starting Device and Setting Humidity

EN 9
dehumidifier TTK 71 E
Operation
Notes:
• Avoid open doors and windows.
• After being switched on, the device operates fully
automatically.
• The fan permanently runs in dehumidification mode even
after the set nominal value has been reached until the
device is switched off.
Operating elements
1110 12 13
1419 15161718202122
9
No. Designation Meaning
9 Decrease value
arrow button
Setting the desired relative room
humidity
Setting the number of hours for
the timer function
10 Segment display Indicates the desired relative
room humidity
Indicates the desired number of
hours during timer setting.
11 Increase value
arrow button
Setting the desired relative room
humidity
Setting the number of hours for
the timer function
12 STAND-BY button Power button:
Switches the device on or off.
13 OPERATION indication Is displayed after the device has
been switched on.
14 TANK FULL indication Is displayed when the
condensation tank is full or not
installed correctly.
15 DEFROST indication Is displayed when automatic
defrosting is in progress.
No. Designation Meaning
16 TIMER indication Is displayed when the timer is
activated.
Indicates the number or hours
set.
Is displayed= automatic switch-
off enabled.
17 TIMER button Starts programming for the timer
function.
18 MODE button Selection of the operating mode
"FAN", "LOW", "HIGH", "AUTO"
19 AUTO indication Is displayed when automatic
dehumidification is active.
20 HIGH indication Is displayed when the high fan
speed is activated (function for
laundry drying). Additionally,
room air dehumidification is
activated.
21 LOW indication Is displayed when the low fan
speed is activated. Additionally,
room air dehumidification is
activated.
22 FAN indication Is displayed when the ventilation
mode is activated (no
dehumidification of room air).
Switching the device on
Once you have completely installed the device as described in
the Start-up chapter, you can switch it on.
1. Press the STAND-BY button(12).
ð The OPERATIONindication (13) is illuminated.
ð The unit starts to dehumidify.
Setting the operating mode
Setting the desired relative room humidity
Please proceed as follows to adjust the room humidity value:
1. Press the increase value(11) or decrease value arrow
button(9) to set the desired relative room humidity. Setting
is possible in the range between 30% and 80%.
ð The desired relative room humidity level is indicated on the
segment display(10).