3411-B Error Codes
Code
Mode
test condition.
Microprocessor memory board
hardware failure.
exceeds display size.
Position of PWR/TIME switch
was changed during
accumulation OR hardware
failure on I/O board.
11
Two keys depressed, defective
keyboard or hardware failure
on I/O board.
evaluate the log of a
negative number.
Incorrect depth selected by
DEPTH switch.
attempted to divide by
zero.
No standard counts in the MS
or DS registers.
division.
Incorrect depth selected by
DEPTH switch OR standard or
measure counts are not valid.
division.
MOISTURE
CORRECTION switches.
Switch failure, I/O board
failure, or operator induced
error during chain calculations.
DEPTH switch.