Section 3: Assembly
5. Placeone end of needlenose pliers on bottom of axle
and other end of pliers on top of e-ring. Seate-ring by
pressing pliers closed.
6. Repeat step 3 through 5 to secure second wheel.
8. To aid support leg assembly,rest generator on cradle,
engine end down.Attach support leg with two
M8x 16mm cap screws and two locking hex nuts as
shown.
9. Use two 13mm wrenches to tighten leghardware.
Restgenerator on wheels and support leg.
IO. Center handle bracket on generator frame at support
leg end of cradle, asshown.
I I. Use two 13mm wrenches to attach handle bracket
with two M8 x 45mm cap screws and two lockinghex
nuts.
12. Check that all fasteners are tight and the tires are
inflated to the value marked on the tire or within
15and 40 psi.
BEFORE STARTING THE
ENGINE
To fill your engine with oil:
• Place generator on a level surface.
• Follow the oil grade recommendations and oil fill
instructions given in the engine owner's manual.
NOTE=The generator's revolving field rides on a
prelubricated and sealed ball bearing that requires no
additional lubrication for the life of the bearing.
Add Fuel
_ ARNING! NEVERfill fuel tank indoors.NEVER
fillfuel tank when engineis running or hot.Allow unit
to cool for two minutes before refueling.DO NOT
lighta cigarette or smoke when filling the fuel tank.
_ WARNING! DO NOT overfill the fuel tank.
Always allow room for fuel expansion.
• Place generator on a level surface.
• Follow the fuel grade recommendations and fuel fill
instructions given in the engine owner's manual.
Add Oil
CAUTION! Any attempt to crank or start the engine
before it hasbeen properly filled with the recommended
oil may result in an engine failure.
To Next Page
Loading...
Need help?
General
