Troy-Bilt 2620 - Page 8

Finish securing chute control assembly to chute support 3.
bracket with wing nut and hex screw removed earlier.

Check that all cables are properly routed through the cable 
guide on top of the engine. See Fig. 3-5.
Figure 3-4
Set-Up
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. Store them in your snow

Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-7.
Figure 3-6
Chute Clean-out Tool
Figure 3-7
Figure 3-5
8 se c t i O n 3— as s e M b l y & se t -up