Troy-Bilt 31AS6BN2711 User Manual

IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Chute
Chute Control Rod
Wing Knobs
778-10555A© 2005 31AS6BN2711
Tighten wing knobs.
Pivot handle upward.
Remove flat washer and hairpin clip.
Insert chute control rod into bracket as
shown. Secure with washer and clip.
Place chute over base and close flange keepers (3).
Keepers will click into place when properly secured.

Troy-Bilt 31AS6BN2711 Specifications

General

Brand	Troy-Bilt
Model	31AS6BN2711
Category	Snow Blower
Language	English

Summary

Initial Snowblower Setup

Pivot Handle Upward

Adjust the snowblower handle by pivoting it upwards for proper positioning.

Tighten Wing Knobs

Secure the snowblower components by tightening the wing knobs.

Secure Chute Assembly

Place the chute over the base and engage flange keepers to secure it.

Connect Chute Control Rod

Insert and secure the chute control rod into the designated bracket.

Starting the Snowblower Engine

Fuel and Oil Check

Fill the fuel tank and check the oil level before starting the engine.

Adjust Throttle and Choke

Set the throttle to fast and the choke to full choke for starting.

Connect Power Cord

Connect the power cord to the switch outlet on the engine.

Insert Ignition Key

Push the ignition key into the slot, ensuring it snaps into place.

Prime the Engine

Press the primer bulb three times to prime the engine.

Start the Engine

Press the starter button for up to five seconds to start the engine.