To Next PageTo Next Page
Need help?Do you have a question about the Troy-Bilt Storm 3090XP and is the answer not in the manual?
General| Clearing Width | 30 inches |
|---|---|
| Intake Height | 21 inches |
| Speeds | 6 forward / 2 reverse |
| Electric Start | Yes |
| Headlight | Yes |
| Throwing Distance | 40 feet |
| Auger | Steel |
| Chute Rotation | 200 degrees |
| Chute Control | Remote |
| Clearing Depth | 21 inches |
Read and follow all instructions before assembly and operation.
Inspect the area and remove foreign objects before use.
Use extreme care when handling gasoline due to flammability and explosive vapors.
Guidelines for machine maintenance and proper off-season storage.
Lists all items included in the snow thrower packaging.
Instructions for attaching and securing the snow thrower handle.
Information on storing and using replacement auger shear pins.
Location and preparation of the chute clean-out tool.
Checking and adjusting tire pressure before operation.
Adjusting skid shoes based on surface conditions for proper clearance.
Controls ground speed, direction, and engages the drive system.
Adjustable components that set ground clearance based on surface conditions.
Rotating components that draw snow into the auger housing.
Engages the augers for snow throwing action; release to stop.
Left and right controls located on the underside of the handles for steering.
Controls the direction and angle of snow discharge via a joystick.
Controls snow discharge direction and angle using buttons and joystick pivots.
Manual adjustment of chute rotation and discharge angle using a control rod.
Tool for safely clearing snow and ice from the chute assembly.
Procedures for starting and stopping the snow thrower's engine.
Instructions for replacing sheared auger shear pins.
Refer to the Engine Operator's Manual for engine-specific maintenance.
Checking and replacing wear components like the shave plate and skid shoes.
Lubrication points for the gear shaft and axles to ensure smooth operation.
Cleaning and lubricating wheel axles for proper function.
Procedure for lubricating the auger shaft and related bearings.
Checking and adjusting the drive control cable for proper engagement and free rolling.
Adjusting the shift cable to ensure full range of forward and reverse speeds.
Refer to Assembly & Set-Up for auger control cable adjustment instructions.
Refer to Assembly & Set-Up for chute assembly adjustment instructions.
Refer to Assembly & Set-Up for skid shoe adjustment instructions.
Adjusting the chute control rod for 4-way directional control.
Adjusting the chute control rod for electric directional control.
Instructions for preparing the snow thrower for storage during warmer months.
Procedure for removing and replacing the auger drive belt.
Procedure for removing and replacing the snow thrower's drive belt.
Inspect the friction wheel for signs of wear or cracking if the unit fails to drive.
