Troy-Bilt 5524-Storm User Manual

m _m_B
Operator's Manual
Two-Stage Snow Thrower
5524--Storm
IMPORTANT:READSAFETYRULESANDINSTRUCTIONSCAREFULLY
WARNING: This unit isequippedwith an internal combustion engineand should not be usedon or nearany unimproved forest-covered, brush-covered or
grass-covered land unless theengine's exhaust system isequipped with a spark arrester meeting applicable local or state laws(if any). If aspark arrester isused, it
should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public
ResourcesCode). Other states may havesimilar laws. Federallaws apply on federal lands. A spark arrester for the muffler isavailable through your nearest engine
authorized service dealer or contact the service department, P.0. Box 361131 Cleveland,Ohio 44136-0019.
TROY-BILTLLC,P.O.BOX361131CLEVELAND,OHIO44136-0019
PRINTED IN U.S.A. FORM NO. 769-01278
(7/8/2004)

Troy-Bilt 5524-Storm Specifications

General

Brand	Troy-Bilt
Model	5524-Storm
Category	Snow Blower
Language	English

Summary

Safety First: Read All Instructions Carefully

Section 1: Essential Safe Operation Practices

Training and Preparation Essentials

Safe Operation Procedures

Maintenance and Storage Guidelines

Operator Responsibility and Safety Labels

Understanding Snow Thrower Safety Labels

Identifies and explains critical safety labels attached to the snow thrower.

Section 2: Assembling Your Snow Thrower

Section 3: Know Your Snow Thrower Components

Auger, Drive, and Chute Controls

Information on operating the auger, drive, and chute directional controls.

Section 4: Operating Your Snow Thrower

Before Starting Procedures

Steps to take before starting the engine, including fuel and oil checks.

Starting Methods Explained

Detailed instructions for starting the engine using electric or recoil starters.

Engaging Drive and Augers

How to engage the drive system and the augers for snow throwing.

Auger Control System Test

Procedure to test the auger control for proper engagement and disengagement.

Section 5: Making Component Adjustments

Shift Rod Adjustment Procedure

Chute Assembly Angle Adjustment

Drive and Auger Control Cable Adjustments

Adjusting drive and auger control cables for proper function.

Skid Shoes & Chute Bracket Adjustments

Section 6: Maintaining and Servicing Your Snow Thrower

Engine, Lubrication, and Gear Maintenance

Auger Belt Replacement Guide

Drive Belt Replacement Guide

Friction Wheel Removal and Replacement

Section 7: Off-Season Storage Procedures

Section 8: Troubleshooting Common Issues