Auger Control
carefully read and follow all the instructions below.
is operating safely and properly.
Check the adjustment of the auger control as follows:
When the auger control is released and in the disengaged
In a well-ventilated area, start the snow thrower engine. 2.
3.
thrower), engage the auger.
Allow the auger to remain engaged for approximately ten
several times.
With the throttle control in the FAST (rabbit) position and 5.
the front of the machine.
Confirm that the auger has completely stopped rotating
If the auger shows ANY signs of rotating,
ALL moving parts to stop before readjusting the auger control.
To readjust the control cable, loosen the hex jam nut on the 7.
8.
pliers and tighten the jam nut against the ferrule.
adjustment has been achieved.
11se c t i O n 2 — as s e M b l y & se t -up
To Next Page
Loading...
Need help?
General
