Trueshopping
www.TrueShopping.co.uk
Page: 17 of 42
6. Using the plug spanner/screw driver combination, turn
the nut anti-clockwise until it comes off. It should be quite
easy and take less than two turns.
7. Place the plug spanner on to the large nut. Using the plug
spanner/screw driver combination, turn the nut
anti-clockwise until it comes off. It should be quite easy
and take less than two turns.
8. Take off the nut and the top part of the bicycle bell like
object (it is round like a very small saucer) and keep the
both safe as you will need them for the brush cutter. You
will need to replace them when putting the strimmer in
storage.
9. Remove the Allan key keep it handy to attach the
protective cover. Return the other tools to your tool kit.
10. Now take the strimmer cord storage container (strimmer
spool) and screw it clockwise onto the spindle that is now
visible. Turn it several times, clockwise until it is hand
tight. Your strimmer spool is now attached to your Multi
Tool.
11. Attach the protective cover to the strimmer unit by first
removing the four small nuts on the oblong strip which is
to one side of the strimmer head.
12. Place the protective cover onto the four spindles now
showing and then replace the small nuts using the Allan
key. Attach securely.
13. Test to check that everything is secure.
14. You are now ready to use your strimmer.
To Next Page
Loading...
