Trueshopping
www.TrueShopping.co.uk
Page: 16 of 42
Attaching the Strimmer Spool
These are the parts you need:
1. The long handle as shown.
2. The protective cover as
shown.
3. The strimmer unit
4. The black, round strimmer
cord container (strimmer spool).
5. The following tools from the
tool kit: The Allan key, the plug
spanner and the screwdriver.
Attach strimmer unit to the handle
as follows:
1. Take the silver end of the
strimmer handle (the far end) and
find the hole on the large outer
silver ring.
2. Twist this outer silver ring
until the hole lines up with another hole just underneath
on an inner ring.
3. Now look through the hole and you will see a spindle
inside.
4. Place the plug spanner on to the large nut and turn whilst
looking through the holes at the spindle. Stop turning the
nut when you can see the hole which is drilled into the
spindle. This needs to be lined up with the inner and outer
ring holes.
5. Place the Allan key through all three holes to keep them
locked and lined up.
To Next Page
Loading...
