TSC Alpha-2R

15
3.2 Charge the Battery
3.2.1 Charge the Battery
It takes 1.5 to 2 hours to fully charge the battery before the first time usage. The lifetime of the battery is 300 times for
charge/discharge cycles.
1. Open the interface cover and plug the power cord
into the power jack.
Note:
Please switch OFF printer power prior to plug in the
power cord to printer power jack.
When the battery is charging, please do not remove
the battery from the printer, otherwise, please re-
plug the power cord into a power outlet.
2. Plug the power cord into a properly power outlet.