Need help?Do you have a question about the TSC TDP-244 Series and is the answer not in the manual?
General| Resolution | 203 DPI (8 dots/mm) |
|---|---|
| Max Print Width | 4.09" (104 mm) |
| Print Method | Thermal Transfer/Direct Thermal |
| Max Print Speed | 5 ips (127 mm/sec) |
| Max Print Length | 2, 286 mm (90") |
| Interface | USB 2.0 |
| Operating System Compatibility | Windows, Linux |
| Label Width | 1" (25.4 mm) ~ 4.4" (112 mm) |
| Label Thickness | 0.06 mm - 0.19 mm |
| Power Supply | 100-240V AC, 50/60Hz |
Detailed instructions on how to load label rolls into the printer, including using the spindle and guides.
Guide on how to load labels specifically for use with the peel-off module.
Instructions on how to load labels when the cutter module is installed.
Procedure to calibrate the gap/black mark sensor sensitivity for accurate media detection.
Explains the process for calibrating sensors, performing self-tests, and entering dump mode.
Process to clear DRAM and restore printer settings to factory defaults.
Steps to configure the black mark sensor as the primary media sensor and calibrate it.
Steps to configure the gap sensor as the primary media sensor and calibrate it.
To Next Page
