Why is my TSC Barcode Reader printing with poor quality?
Poor print quality may be caused by several factors. Try cleaning the thermal print head or adjusting the print density setting. Ensure that the ribbon and media are compatible and that the media thickness is within the specified range. Also, check if the correct power supply is connected to the printer.
What to do if TSC TTP-244 ON-LINE indicator is off and ERR. indicator is on?
If the printer beeps once, this indicates a gap sensor problem. Calibrate the gap sensor or set the paper length correctly in the labeling software/program, and ensure the paper is installed correctly. If the printer beeps twice, it indicates a ribbon sensor problem. Ensure that an outside wound ribbon is used, the ribbon is threaded correctly, and a paper core is installed on the ribbon take-up spindle. You may also need to calibrate the sensitivity of the gap sensor.
How to fix TSC TTP-244 Barcode Reader when the ribbon does not advance or rewind?
Ensure the media and ribbon are installed, and the print head mechanism is engaged before turning on the printer. Verify that the black ribbon spindle is installed in the correct direction. Also, check the "Media settings method" in the driver to confirm it is not set to direct thermal mode.
What to do if the TSC Barcode Reader power indicator does not illuminate?
First, check the power cord to ensure it is properly connected. Also, verify if the LED on the power supply is illuminated; if not, the power supply might be damaged. Finally, make sure the correct power supply is connected to the printer.
How to stop continuous feeding when printing labels on TSC Barcode Reader?
To resolve continuous feeding, check the driver or command script setting to ensure the sensor type is set correctly. If you are using die-cut media, try calibrating the gap sensor again.
Details regulatory compliances for the printer, including CE and FCC standards.
Guidance on inspecting the printer package and device for damage upon receipt.
Lists all included components and accessories for the printer package.
Identifies and labels the external components and parts of the bar code printer.
Details the optional external label roll mount accessory for the printer.
Explains the function of the printer's buttons and status indicator lights.
Step-by-step instructions for physically setting up the printer on a surface and connecting it.
Procedure for installing and feeding label and tag stock into the printer.
Detailed steps for correctly installing the thermal transfer ribbon into the printer.
Instructions for mounting and setting up the optional external label roll holder.
Guide to performing the printer's self-test routine to check functionality and print settings.
Explanation of the dump mode for verifying programming commands and debugging printer issues.
Procedure for installing an SD memory card in TTP-244 Plus models for data storage.
Performs label calibration, print head check, and displays internal settings.
Calibrates the gap sensor sensitivity for accurate media detection.
Resets printer parameters to default values without clearing flash memory.
Lists common problems and their solutions for operating the bar code printer.
General| Print Resolution | 203 DPI |
|---|---|
| Print Method | Thermal Transfer / Direct Thermal |
| Max. Print Speed | 4 ips (inches per second) |
| Max. Print Width | 4.09 inches (104 mm) |
| Processor | 32-bit RISC |
| Interface | USB |
| Maximum Print Width | 4.09 inches (104 mm) |
| Supported Barcodes | Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, Interleaved 2 of 5, Codabar, POSTNET |
| Power Supply | 100-240V AC, 50/60Hz |
To Next Page