Need help?Do you have a question about the TSC TTP-244M Pro and is the answer not in the manual?
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 DPI |
| Processor | 32-bit RISC |
| Ethernet | Optional |
| Media Type | Roll, Fanfold, Die-Cut |
| Power Supply | AC 100-240V, 50/60Hz |
| Operating Temperature | 5°C - 40°C |
| Memory | 8 MB Flash Memory |
| Interface | USB, Serial (RS-232) |
| Media Width | 25.4 mm |
| Label Thickness | 0.06 mm |
| Storage Temperature | 60°C |
| Humidity | 85% non-condensing |
Lists all included printer accessories and optional items.
Identifies components of the printer's front exterior using numbered labels.
Details internal printer components with numbered labels for identification.
Shows and explains the external interfaces and ports located on the printer's rear.
Explains the function of status indicators (POWER, ON-LINE, ERROR) and control buttons (MENU, PAUSE/SELECT).
Details the dual functions of the FEED and SET buttons for advancing labels and changing settings.
Provides step-by-step instructions for connecting and setting up the printer.
Illustrates the correct procedure for installing a thermal transfer ribbon.
Guides users on how to properly load label media into the printer.
Details the procedure for loading media in the optional peel-off dispensing mode.
Explains how to load media when using the printer's optional integrated cutter.
Describes performing a self-test to check printer hardware, print a check pattern, and view internal settings.
Guides on calibrating the gap sensor for accurate media detection.
Details the process to reset printer parameters to their factory default values.
Instructions on how to start and access the printer's diagnostic utility software.
Lists and explains the various functions available within the diagnostic tool for printer management.
To Next Page
