TSC TTP-245 Plus - User Manual

Questions and Answers

C
Christian DeleonAug 13, 2025
How to improve poor print quality on a TSC Barcode Reader?
- D
  dawngillAug 13, 2025
  To improve the print quality of your TSC Barcode Reader, consider the following: * Ensure the top cover is completely closed and latched. * Reload the supply to make sure it is loaded correctly. * If the print is faded or inconsistent, adjust the print density and print speed. * If there are white lines or missing elements, clean the print head. * If these steps don't help, run a printer self-test to check the print head test pattern for damage.
C
Charles HillAug 17, 2025
What to do if my TSC TTP-245 Plus Barcode Reader shows an error?
- W
  winterscharlesAug 17, 2025
  If your TSC Barcode Reader displays an error, it might be due to a few reasons: * If the printer is out of labels, load a new roll and press the FEED button. * If the printer is out of ribbon, load a new roll and press the FEED button. * If the error persists, the printer settings may be incorrect. Initialize the printer using the "Power on Utility" or "Diagnostic Tool".
G
Gary MasonAug 20, 2025
Why is my TSC Barcode Reader printing blank labels?
- J
  Joshua StewartAug 20, 2025
  If your TSC Barcode Reader is printing blank labels, consider the following: * Check if the label or ribbon is loaded correctly by following the loading instructions. * Ensure that the ribbon has not run out, and load a new ribbon if necessary.
W
wmillsAug 25, 2025
Why is my TSC TTP-245 Plus not printing?
- M
  Madison BlairAug 25, 2025
  Several factors can cause a TSC Barcode Reader not to print. Here's what to check: * Ensure the interface cable is securely connected. * If using a serial port, verify the cable is pin-to-pin connected, replace if needed. * Confirm the serial port settings match between the host and the printer; reset if necessary. * In the Windows driver, select the correct printer port. * Verify that the Ethernet IP, subnet mask, and gateway are properly configured.
S
Stanley WalkerAug 28, 2025
What to do if TSC TTP-245 Plus Barcode Reader has no response?
- M
  Michael RiversAug 28, 2025
  If your TSC Barcode Reader is not responding, check these items: * Make sure the power switch is turned on. * Verify the green LED is lit on the power supply. If not, the power supply may be broken. * Ensure both power connections, from the power cord to the power supply and from the power supply to the printer, are securely connected.
K
Karen RandolphAug 31, 2025
How to fix a paper jam in my TSC TTP-245 Plus?
- K
  Kristy LeeSep 1, 2025
  To resolve a paper jam in your TSC Barcode Reader: * Calibrate the gap/black mark sensor. * Ensure the label size is correctly set in your labeling software or program to match the installed paper. * Check the printer mechanism near the sensor area for stuck labels and remove them.
J
jessica51Sep 4, 2025
Why is my TSC TTP-245 Plus Barcode Reader continuously feeding labels?
- K
  Kristin GordonSep 4, 2025
  If your TSC Barcode Reader is continuously feeding labels, the printer settings may be incorrect. Perform initialization and gap/black mark calibration to resolve this issue.
L
Lauren BarajasSep 8, 2025
How to resume printing on a paused TSC Barcode Reader?
- J
  Justin WhiteSep 8, 2025
  If your TSC Barcode Reader is paused, simply press the FEED button to resume printing.