EasyManuals Logo

TSC TTP-245 Plus User Manual

TSC TTP-245 Plus
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
24
3.9.2 Using RS-232 interface to setup Ethernet interface
1. Connect the computer and the printer with a RS-232 cable.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicks on the icon.
Note: This utility works with printer firmware V6.00 and later versions.
4. Select “COM” as interface then click on the “Setup” button to setup the
serial port baud rate, parity check, data bits, stop bit and flow control
parameters.
5. Click on the “Ethernet Setup” button from printer function of Printer
Configuration tab to setup the IP address, subnet mask and the gateway for
the on board Ethernet.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TSC TTP-245 Plus and is the answer not in the manual?

TSC TTP-245 Plus Specifications

General IconGeneral
BrandTSC
ModelTTP-245 Plus
CategoryBarcode Reader
LanguageEnglish

Related product manuals