Need help?Do you have a question about the TSC TA200 Series and is the answer not in the manual?
General| Model | TA200 Series |
|---|---|
| Connectivity | RS-232 |
| Scan Rate | 200 scans per second |
| Supported Barcodes | Code 39, Code 128, Interleaved 2 of 5, Codabar |
| Humidity | 5% to 85% non-condensing |
Overview of the TSC bar code printer and its features.
Details the capabilities and offerings of the printer series.
Lists the standard features offered by the TA200 series printers.
Details the optional features available for the TA200 series printers.
Provides physical, electrical, and environmental specifications for the printer.
Outlines the resolution, speed, and size capabilities of the printer.
Details the specifications for ribbon usage, including diameter, length, and width.
Lists media compatibility, width, thickness, and length for different printer models.
Instructions for unpacking the printer and checking for included items.
Provides a visual and descriptive breakdown of the printer's components.
Identifies the components visible on the front of the printer.
Details the internal components and their locations within the printer.
Shows and labels the various ports and connections on the rear of the printer.
Step-by-step guide for initial printer setup and connections.
Guide for installing standard roll labels into the printer.
Instructions for loading media when using the peel-off module.
Steps for loading media when the cutter module is installed.
Procedures for installing an optional external label roll mount.
Explains the meaning of different LED colors and their states.
Describes the basic operations performed by the printer's button.
Details the process for calibrating ribbon and media sensors.
Explains calibration, self-test, and dump mode activated by power-on utilities.
Restores printer settings to factory defaults.
Procedure to configure and calibrate the black mark sensor.
Procedure to configure and calibrate the gap sensor.
How to interrupt the AUTO.BAS program execution on startup.
Guide on launching and accessing the printer diagnostic utility.
Details the functions available within the diagnostic tool for printer setup.
Explains how to calibrate media sensors using the diagnostic tool.
Step-by-step guide for automatic media sensor calibration using the tool.
Instructions for configuring Ethernet settings via the diagnostic utility.
How to configure Ethernet settings via USB connection.
How to configure Ethernet settings via RS-232 connection.
How to configure Ethernet settings via a direct Ethernet connection.
Lists common issues, their causes, and recovery procedures for the printer.
To Next Page
