TSC Alpha-2R

32
6. TroubleShooting
Problem
Possible Cause
Recovery Procedure
Power indicator does not illuminate
* The battery is not properly installed.
* The battery is dead.
* Reinstall the battery.
* Switch the printer on.
* Charge the battery.
- The printer status from TSC
Console shows “Head Open”.
* The printer carriage is open.
* Please close the print carriage.
- The printer status from TSC
Console l shows “Out of Paper”.
* Running out of media roll.
* The media is installed incorrectly.
* Black mark sensor is not calibrated.
* Supply a new media roll.
* Calibrate the black mark sensor.
- The printer status from TSC
Console shows “Paper Jam”.
* Black mark sensor is not set properly.
* Make sure media size is set properly.
* Media may be stuck inside the printer
mechanism.
* Calibrate the black mark sensor.
* Set media size correctly.
Memory full
( FLASH / DRAM )
* The space of FLASH/DRAM is full.
* Delete unused files in the FLASH/DRAM.
* Run printer self-test and check the
available memory space for DRAM or
FLASH.
* Check the available memory space
for DRAM or FLASH via DiagTool.
Poor Print Quality
* Media is loaded incorrectly
* Dust or adhesive accumulation on the print
head.
* Print density is not set properly.
* Print head element is damaged.
* Reload the supply.
* Clean the print head.
* Clean the platen roller.
* Adjust the print density and print speed.
* Run printer self-test and check the print head test pattern if
there is dot missing in the pattern.
* Change proper media roll.