TSC PEX-2000 Series - Page 26

24
3. Adjust the front label guide to fit the label width. Make sure the label through the front gap media sensor.
Left-hand model
Right –hand model
Note:
⚫ For the thick media (0.9 mm ~ 1.2 mm) , a tool can be used to lift the front gap media sensor upward to facilitate media installation.
Left-hand model
Right-hand model
⚫ The printer's default gap media sensor setting is on the label holder cover (rear), with the green media sensor LED. If you want to use
the front gap sensor, enter the operation menu list. Select [Sensor] and then set the [Gap Location] from [Back] to [Front].
Please refer to ch.5.3 (Sensor) for more information.
Front gap media sensor
Front gap media sensor
Front label
guide
Front label
guide