TSC PEX-2000 Series - SBPL (Only Available on EZS Version Firmware)

53
5.2.3 SBPL (Only available on EZS version firmware)
Item
Description
Default
Print Type
This item is used to set the print mode. There are three modes as below,
Dispenser
Once printer complete printing 1 label, it will wait for being
removed.
Rewinder mode
The print engine prints without pausing between labels.
The media is wound onto a core after printing.
Continuous
Print the specified number of media
Dispenser
Print Darkness
Use this item to setup printing darkness. The available setting range is from 0 to
10. You may need to adjust your density based on selected media.
3
Print Speed
Use this item to setup print speed. Available setting range is 2~18 for 203dpi and
2~14 for 300dpi
203 dpi: 6 ips
300 dpi: 4 ips
Slew Speed
Use this item to setup feed speed. Setting value is up to 8 ips.
203 dpi: 6 ips
300 dpi: 4 ips
BackFeed Speed
Use this item to setup back feed speed. Setting value is up to 6 ips.
2 ips
Offset
Use this item to adjust the offset position. Offset adjusts the back/feed/stop
position for Tear-off/Cut/Dispense operation.
0 dot
Pitch
Use this item to adjust the leading edge of media position thus effects the vertical
print position placement.
0 dot
Setting SBPL
Print Type
Dispenser
Rewinder
Mode
Continuous
Print Darkness
Print Speed(S)
Slew Speed(S)
BackFeed Speed(S)
Offset
Pitch