This menu item determines if errors are declared when the Label Retry count
is exceeded.
This RFID button is used to do RFID calibration, and get
the three parameters through RFID calibration.
Note:
Before performing an RFID calibration, you will first
need to select the right sensor for your RFID labels
and run a media sensor calibration.
It is read-only and used to show the number of tags
attempted to be written/ failed/ read RFID tags since the
last Clear Tag Stat operation has been initiated.
Press “Reset Counter” button to Clear Tag Stat.
Note: Please refer to Ch.5.5.7 for more information.
To Next Page
Loading...
