TSC PEX-2000 Series - Page 53

51
Item
Description
Default
Density
Set the printing darkness. Available setting range: 0 to 30.
16
Print Speed
Set the print speed.
203 dpi: 6
300 dpi: 4
Slew Speed
Set feed speed
203 dpi: 6
300 dpi: 4
BackFeed Speed
Set back speed
2
Tear Off
Adjust media stop location. Available setting value range: -120~120 dots.
0 dot
Print mode
Set the print mode. There are 4 modes in total:
Tear Off: Once finishing the printing process, label will be fed to the tear plate location.
Applicator: The printer prints a label when it receives a signal from the applicator.
Stream:: The print engine prints a batch of labels with backfeed occurring only at the start
and end of the batch instead of between individual labels.
Rewind: Enable the label rewinder mode.
Tear Off
Print Width
Set the print width. Available setting range: 2 ~ 999 dots.
812
List Fonts
Print the current fonts list from the memory devices to the label.
N/A
List Images
Print current printer available images list stored at the memory device to the label.
N/A
List Formats
Print current printer available formats list from the memory devices to the label.
N/A
List Setup
Print current printer configuration to the label.
N/A
Control Prefix
Set control prefix character.
N/A
Format Prefix
Set format prefix character.
N/A
Delimiter Char
Set delimiter character.
N/A