TSC PEX-2000 Series - Page 78

76
Date & Time
Setup the date and time on display.
N/A
Security
Set the password for locking the menu or favorites. The default password is 8888.
Disable
Ribbon Wound
Set the ribbon wound direction.
Ink Side Out
Ribbon Tension
Set the ribbon tension.
Medium
Ribbon Low Warning
Set the warning for ribbon low. For example, if setting value is 30m, when ribbon
capacity was lower than 30m, the will be shown in red.
30M
Printer Head Maintn
Check printhead status and to set the settings for printhead care.
Warning: Enable/disable the printhead clean warning. If enable this feature, once
printhead has been reached the setting mileage then the warning icon will be shown
on printer UI for reminding user to clean the printhead. The default setting is disable.
Reset Counter: Reset the printhead clean warning mileage after cleaning printhead.
Interval: This item is used to set the expected mileage for reminding user to clean the
printhead. You have to enable the “TPH warning lock” for use. The default setting is 1
km.
N/A
Key Sound
This item is used to enable/disable the sound of front panel buttons.
ON
Pause Mode
This item is used to enable/disable the printer into pause mode (Off line). After
selecting “enable”, press the down arrow key and the printer will pause all actions.
Disable
LCD Invert
Depending on the printer orientation, the display can be set to 0° (standard) or 180°.
(Yes/ No)
NO
Contact Us
Check the contact information for tech support service.
N/A