TSC PEX-2000 Series - Page 84

82
Delay1
After detecting the following function condition, the printer will wait this period of time before sending out the
“false” output signal.
Unit: millisecond. Maximum: 32000.
Pulse1
Pulse width corresponding to the function condition becoming “false”. (Ignored for level-type signals.)
Unit: millisecond. Maximum: 32000.
Function
condition
(warning, error,
control…)
FAULT
Printer fault.
FAULT RIBBON
Ribbon error is occurred.
FAULT PAPER
Paper empty or paper jam is occurred.
FAULT CARRIAGE
Carriage is open.
FAULT MEMORY
Out of memory is occurred.
FAULT CUTTER
Cutter error is occurred.
FAULT OVERHEAT
Stepping motor or printhead is over heat.
PAUSE
Pause status is occurred.
TAKELABEL
Take label is occurred.
IDLE
Printer is idle.
PRINT
Printer is printing.
Sample Code
Example
SET GPO1 HIGH,100,0,100,0,FAULT RIBBON
SET GPO2 LOW,100,0,100,0,FAULT PAPER
SET GPO3 POS,100,100,100,100,PAUSE
SET GPO4 NEG,100,50,100,50,IDLE