3.9 Replacing the Wi-Fi Mudule
1. Refer to section 3.1 take the printer top cover off. Disconnect the Wi-Fi antenna connector carefully.
2. Refer to section 3.2 to remove the keys control board.
3. Remove one screw on the Wi-Fi control board. Please refer to above picture.
4. Replace the WiFi control board.
5. Reassemble the parts in the reverse procedures.
Note:
This is the new Wi-Fi module’s replacing instruction. It should work with the main board that is -30LF version. (or later version)
If you replace the main board, please check the Wi-Fi signal band on configuration page for your using region. If any questions,
please contact the Customer Service Department of your purchased reseller or distributor for assistance.
To Next Page
Loading...
