TR-I serial wireless crane scale user’s manual
- 8 -
SECTION 7 PARAMETERS
The scale has 8 parameters that can be set by the user plus a method of entering the
calibration section.
Turn off the power if you are using the scale. then turn on the power, press the UNIT
key at the same time during self-checking.
Display shows “Pn---”, waiting for input password, Input password, HOLD key; UNIT
key and ZERO key. Then press the ZERO key to enter in.
The display will show the first function, "F0 div".
Pressing the DIV key will cycle through the other functions.
Pressing ZERO will allow you to set the function. It may be necessary to either use
DIV or set a value using the HOLD key to move the active digit and then using the
DIV key to increment a digit, followed by the ZERO key to enter the value. Use the
UNIT key to leave a parameter unchanged.
For example when the display shows “F0 DIV”, then press the DIV key to select “F1
az0”, press the ZERO key to begin.
The display will show “az 0.5d”, press the ZERO key to ensure, or press the DIV to
the next parameter. When you select a suitable value, press the ZERO key to
ensure.
After pressing the ZERO key to set a value, use the DIV key to continue to the next
parameter and set it as needed.
When all digits have been set press the ZERO key to store the value. The display
will go back to the parameter just set, Advance to another parameter if needed or
press the UNIT key to return to weighing.
FUNCTION MENU SETTINGS
To Next Page
Loading...
