TScale TR-I Series - SECTION 10 CALIBRATION

TR-I serial wireless crane scale user’s manual
- 12 -
SECTION 10 CALIBRATION
1) Turn off the power if you are using the scale.
2) Then turn on the power, press UNIT key at the same time during selfchecking.
3) Display shows “Pn---”, waiting for input password.
4) Input password, HOLD key; UNIT key and ZERO key. then press the ZERO key to
enter in.
5) Display will shows “F0 div”, press DIV key until display shows “F8 CaL”
6) Press ZERO key to enter calibrate, display shows “ULOAD”
7) Empty the hook, after STABLE indicator on, press ZERO key to sure, after some
seconds, zero calibrate completely.
8) After zero calibrate, display shows span calibrate mass weight, you can change
this weight, (use HOLD key to move the active digit, use DIV key to increment a
digit), after input calibrate mass weight, press ZERO key to sure, display show
“LOAD”, add calibrate mass on hook, after stable indicator on, press ZERO key
again, please wait some seconds, span calibrate completely.