TR-I serial wireless crane scale user’s manual
- 13 -
SECTION 11 ERROR CODES
Remove weight from the scale.
If the problem persist contact your dealer or
Taiwan scale for assistance.
The scale was outside the normal auto zero
setting range (4% of capacity), please check the
hook is empty, or calibrate zero point again.
Keyboard short, please check the key wire or
whether the key have mechanical problem
The values from the A/D converter are outside the
normal range. Remove weight from the scale if
overloaded, make sure the pan is attached.
Indicates the load cell or the electronics may be
faulty.
If the problem persist contact your dealer or
Taiwan scale for assistance.
No single has been
received
Check if the distance is too long or the
environment is too bad.
The protocol is not
right or suitable
Charge battery immediately
To Next Page
Loading...
