TScale TR-I Series - SECTION 4 KEY DESCRIPTIONS; Zero; DIV; HOLD

TR-I serial wireless crane scale user’s manual
- 4 -
SECTION 4 KEY DESCRIPTIONS
Zero
Set the zero point for all subsequent weighing. The display shows zero.(only when
the weight is less than 10% capacity)
Tare the scale. Stores the current weight in memory as a tare value, subtracts the
tare value from the weight and shows the results. This is the net weight. Entering a
value using the keypad will store that value as the tare value. (only when the weight
is large than 10% capacity)
A secondary function , of "Enter" key when setting parameters or other functions.
DIV
Change the division of the scale. This scale has two division (high and low) could be
selected,
A secondary function , of incrementing the active digit when setting a value for
parameters or other functions.
HOLD
reading lock key, use this key to lock reading, in calibrate mode, use this key to
change decimal point.
Secondary function , In the setting mode, this key used to move active digits
right.
M+
To print the results to a PC or printer using the optional RS-232 interface. It also
adds the value to the accumulation memory if the accumulation function is not
automatic.
Secondary function ( C or ) , is to act as a clear key or to move active digits
left when setting values for parameters or other functions.
UNIT or U
Press this key to select the weight unit. Move the active digit left when setting values
for other functions.
Secondary function (ESC) , is to return to normal operation when the scale is in a
parameter setting mode.
ON/ OFF
Turn on or off the power.