37
Setup Commands for Analog Output
SASnnn
Sets the full-scale flow rate of the analog output.
SAZnnn Sets the zero intercept for the analog output.
SSRnnnn Sets the sample rate at which the data is returned.
Miscellaneous Commands
Rxx
Reads the current values of the changeable
operating parameters.
SAVE Saves the current values of changeable operating
parameters to nonvolatile memory.
DEFAULT Restores the values of changeable operating
parameters to factory default settings.
SN Returns the serial number of the flowmeter.
MN Returns the model number of the flowmeter.
REV Returns the internal firmware revision of the
flowmeter.
DATE Returns the date of the last calibration.
? Ping command used to tell if the flowmeter is
communicating. Returns “OK”.
To Next Page
Loading...
