38
Command Set
DmFTPnnnn
Returns Flow, Temperature, and Pressure data at an interval equal to
the sample rate.
The data is returned in the order of Flow, Temperature, and Pressure.
All three measurements may be requested or a combination of the
three as indicated below.
D Denotes data transfer.
m Denotes data format: A = ASCII (comma delimited),
B = binary, C = ASCII (<CR> delimited).
F Requests a flow reading (replace with lower case ‘x’ if a flow
reading is not desired).
Flow data is returned in units of Standard L/min or L/min (see
SUs command).
T Requests a temperature reading (replace with a lower case
‘x’ if a temperature reading is not desired). Temperature data
is returned in units of °C.
To Next Page
Loading...
