46
Example 2) VA1000 Request volume measurement with at most
1000 samples, data returned in ASCII.
Flowmeter immediately returns the acknowledgement
OK <CR> <LF>. After the end of the data acquisition
period when the end-trigger condition is detected or
when the specified number of samples have been
collected, volume data is transmitted followed by the
termination sequence: 130.651 <CR> <LF>
Example 3) VB1000 Request volume measurement with at most
1000 samples with the data returned in binary.
Flowmeter returns the single byte acknowledgement
0x00. At the end of the data acquisition period when
the end-trigger condition is detected or when the
specified number of samples have been collected,
volume data is transmitted followed by the
termination sequence: 0x33 0x09 0xFF 0xFF. After
conversion, the data would look like: 130.65
To Next Page
Loading...
