TSI Instruments FHC50 - Page 24

Part Two
16
CONFIGURE
CONFIG WIZARD
NORM CTRL MODE
SETB CTRL MODE
VEL SENSOR
FLOW DEVICE
DISPL SOFTKEYS
DISPLAY MEAS
DISPLAY AVG
DISPLAY UNITS
ALARM RESET
EMERGENCY AUD
MUTE BUTTON
MUTE TIMEOUT
ALARM DELAY
ANALOG OUT TYPE
ANALOG OUT SIG
ANALOG OUT F.S.
RELAYS OUT
RELAY SEL A
RELAY SEL B
INPUT SEL 1
INPUT SEL 2
INPUT SEL 3
NUMBER FORMAT
CONTRAST
SPECIALS MENU
ACCESS CODE
SETPOINTS
SETPOINT
SETBACK
SETB CNTL POS
MIN CONTROL POS
MAX CONTROL POS
MIN FLOW
MAX FLOW
LO VEL ALARM
HI VEL ALARM
LO FLOW ALARM
HI FLOW ALARM
SETB LOVEL ALARM
SETB HIVEL ALARM
SETB LOFLO ALARM
SETB HIFLO ALARM
HI SASH POS ALARM
DAMPER ALARM
INTERFACE
NET PROTOCOL
NETWORK
SETTINGS**
CALIBRATION
VEL SENSOR ZERO
VEL SENSOR SPAN
CALIBRATE FLOW
BALANCE MODE
SASH CAL CLOSED
SASH CAL OPEN
SASH AREA OPEN
SASH AREA CLOSED
BALANCE MODE*
DESIRED FLOW
FLOW KFACTOR
UNCORRECTED
FLOW
KF USED
FLOW * KF
CONTROL
SENSITIVITY
SPEED
CONTROL SIG
KC VALUE
TI VALUE
DIAGNOSTICS***
CONTROL OUT
VEL SENSOR INPUT
SHOW FACE VEL
FLOW STATION ANALOG INPUT
SHOW FLOW
ANALOG OUT
ALARM RELAY A
ALARM RELAY B
IN1 SASH CONTACT****
SHOW SASH%OPEN
SHOW SASH AREA
IN2 EMERG PURGE****
IN3 NIGHT SETBACK****
SELF TEST
RESET SETTINGS
RESET ALL CALIBS
Figure 5: Menu Items – Model FHC50 Controller
* BALANCE FLOW submenu only appears if flow sensor is enabled (FLOW DEVICE not set to
NONE).
** Items in NETWORK SETTINGS submenu depend on NET PROTOCOL setting. See
NETWORK SETTINGS item description for details.
*** Menu items located in Troubleshooting section.
**** Menu item name depends on INPUT SEL 1, INPUT SEL 2 and INPUT SEL 3 in
CONFIGURE menu.