TSI Instruments QUESTemp 32 - Keypad Operation; Displayed Items

4 Keypad Operation
Heat Index / Humidex
Keypad Operation
The unit operates using a membrane keypad with four keys. The I/O ENTER key
responds when the key is released while all other keys respond when the key is
pressed.
Keys
Explanation
I/O Enter key
The unit turns on with a single key press. The unit turns off
by holding the key down while a countdown of 3-2-1 occurs
in the lower right corner of the display. This key is also
used to enter setup changes.
While viewing live readings, pressing and releasing the key
will cause the display to view the next available sensor bar
(indicated in the upper right corner of the display).
Up Arrow key
Changes which items appear in the display. Scrolls up.
Down Arrow key
Changes which items appear in the display. Scrolls down.
Setup key
Allows changing the setup parameters. Three parameters
are available: Celsius or Fahrenheit, the language, and
Heat Index or Humidex. Press setup to access the
parameters. Use the arrow keys to switch between the two
parameters. Use the enter key to change the parameters.
Press setup again to exit.
Displayed Items
The number in the upper right corner indicates which sensor bar’s data is displayed.
1 indicates the sensor bar placed on (or attached to) the top of the instrument. Sensors
2 and 3 are labeled on the side of the unit. W indicates the weighted average which only
appears if a WBGT is displayed and all three sensor bars are attached.
Keypad
Operation