TST TM-507 - High Temperature Alarm Settings; High Pressure Alarm Settings

HIGH PRESSURE ALARM SETTINGS
HIGH TEMPERATURE ALARM SETTINGS
TST-Doc-507FT-RV WSD-C Manual-(D)
To set the High Temperature Alarm, press and hold the "SET" button until it beeps.
Press the (+) button twice and "HI TEMP SET" will appear. Again, press the "SET"
button to enter that mode. Use the (+) or (-) buttons to adjust the High
Temperature parameter, if desired. Press "SET" to save. When done press the
"BACK" button.
Note: We recommend leaving this temperature setting at the default 158°F for all
types of tires.
To set up the High-pressure Alarm, press and hold the "SET" button until it beeps.
"HI PRESSURE SET" will appear at the bottom of the screen. Again,press the "SET"
button to enter that mode. Press the "GO"button to select the appropriate axle.
Use the (+) or (-) buttons to adjust the high-pressure alarm to20or25% over your
normal tire pressure for that axle. Press the "GO" button to move to the next axle.
When done setting each axle that you have sensors on, press the "SET" button to
leave that parameter and go back to the menu. When done, press the "BACK"
button to go to the Main Screen.
When you get to the Trailer section of the display, it is set up in three axle groups.
See Page 14 of this manual for more information.