REPLACING THE FLOW-THROUGH SENSOR BATTERY (CR1632)
(1) Remove the sensor from the tire valve stem.
Waterproof
rubber seal
Battery
Battery cover
(2) Using a jewelers Phillip's screwdriver, remove the two screws from the battery
cover on the side of the sensor. The "+" side of the battery can now be seen.
(3) Remove the CR1632 battery and check that the metal contact points in the
sensor are not corroded. To clean the contact points, use a pencil easer and
lightly rub the two metal battery contacts in the sensor.
(4) Install a new battery. Be sure the "+" (positive) side is facing out.
Note: It is recommended that you check the voltage of the new battery before
installation. It should read 3+ volts when new. Do not install if the battery
reads less than 3 volts.
TST-Doc-507FT-RV WSD-C Manual-(D)
Loosen the hex nut
Specified
wrench
To Next Page
Loading...